For quick anchoring of plastic and metal parts in concrete, brick, stone masonry, quick repair of cracks, elimination of water leaks and leveling of concrete surfaces in buildings and structures; The mixture allows filling of gaps with a thickness of 5 mm to 20 mm (with the addition of fine gravel - up to 50 mm); The material is used in the installation process: plumbing and furniture in bathrooms, sockets and electrical appliances, window grilles.
Description
Specifications
FEATURES
– fast-hardening mixture;
– provides strong anchoring;
– has a rapid set of strength;
– has no shrinkage;
– high water and frost resistance;
– for exterior and interior work;
– high level of adhesion and strength.
SUBSTRATE PREPARATION
– the substrate must be strong, sufficiently load-bearing, resistant to deformation, weathered, even
– if necessary, level and repair any unevenness or depressions;
– clean the surface from layers that reduce adhesion (dust, rust, lime, oil, grease, wax, residues of oil and emulsion paints);
– unprotected areas of the reinforcement must be cleaned and treated with a protective mixture;
– in narrow and long areas, arrange expansion joints in accordance with regulatory documentation;
– moisten the surface before starting work
PREPARATION OF THE MORTAR MIXTURE
– the amount of the mixture being prepared should correspond to the possibility of laying in 10 minutes;
– pour water into a clean working container (water temperature from +15 °C to +20 °C);
– water calculation – 0.30-0.35 l per 1 kg of dry mixture);
– gradually add the dry mixture and mix with a low-speed mixer until a homogeneous, pasty mass without lumps is obtained;
– let the mortar mixture stand for about 1 minute, then mix again;
– the solution can be used for up to 10 minutes.
PERFORMANCE OF WORK
– evenly distribute the mortar mixture over the surface or fill the prepared volume;
– remove the remains of the mortar mixture mechanically, preventing the solution from hardening;
– thoroughly wash the tool after completion or stopping the work
COMPOSITION
binder mixture, fractionated aggregates, modifying additives
Water consumption for preparing the mortar mixture:
0.30-0.35 l per 100 kg of the mixture;
Shelf life of the mortar mixture:
up to 10 minutes;
Temperature of application of the mortar mixture:
from +5 °C to +30 °C;
Ultimate tensile strength when bending:
after 6 hours: not less than 2 MPa; after 24 hours: not less than 2.5 MPa; after 28 days: not less than 8 MPa.
Ultimate compressive strength:
after 6 hours: not less than 10 MPa; after 24 hours: not less than 20 MPa; after 28 days: not less than 40 MPa.
Anchor pullout strength:
not less than 100 MPa;
dry mix consumption:
about 1.7 kg per 1 liter of filled volume
From purchase to full work
Drop ship from manufacturer
Certificates for all products
We will contact you shortly
leave a request and we will call you back within an hour
